# ---------------------------------------------------------------- # This file configures a D1 mini for displaying the next waste # container for collection. # # This is done by defining a strip of WS2811 LEDs as light and # setting the color through an automation in HomeAssistant. # The switch in the lid can be used as acknowledge that the # wastebin has been placed for collection. # # D1 wiring: # 5V power for LED strip # G ground for LED strio # D4 (GPIO2) data signal for LED strip # D2 (GPIO4) internal status LED and power for lid switch, # allowing for the disabling of the switch # D3 (GPIO0) lid switch input # # !secret variables are defined in secrets.yaml file # HomeAssistant API is disabled by default. You can enable this # if you prefer this over MQTT. # # ---------------------------------------------------------------- # ---------------------------------------------------------------- # Module configuration # ---------------------------------------------------------------- # Configure generic module settings esphome: #name: esp_5a098d name: wastebin_notifier platform: ESP8266 board: d1_mini # Configure Network settings wifi: ssid: !secret WIFI_SSID password: !secret WIFI_KEY domain: !secret WIFI_DOMAIN # Enable fallback hotspot in case wifi connection fails ap: ssid: !secret FALLBACK_AP_SSID password: !secret FALLBACK_AP_KEY # Enable captive portal in case wifi connection fails captive_portal: # Configure minimal logging logger: level: WARN # Configure Over-the-Air updates ota: password: !secret OTA_KEY ## Configure Home Assistant API #api: # Configure MQTT mqtt: broker: !secret MQTT_BROKER topic_prefix: "test/waste/notifier" # ---------------------------------------------------------------- # I/O configuration # ---------------------------------------------------------------- # Binary sensors ("status" is always available) binary_sensor: - platform: status name: wastebin_status - platform: gpio pin: number: GPIO0 inverted: true name: wastebin_lidswitch filters: # debounce delay - delayed_off: 10ms # Sensors ("uptime" is always available) sensor: - platform: uptime name: wastebin_uptime update_interval: 3600s # Switches ("restart" is always available) switch: - platform: restart name: wastebin_restart - platform: gpio pin: GPIO2 name: wastebin_lidswitch_disable restore_mode: ALWAYS_OFF # Lights light: - platform: fastled_clockless chipset: WS2812 rgb_order: GRB pin: GPIO4 num_leds: 5 name: wastebin_lid